Software - Support > Installing Software

Drivers installed but not "loaded"

(1/6) > >>

Jim0000:

--- Quote from: stevef on August 28, 2022, 02:08:11 AM ---Ok, let's see if we can get the Network icon back.
........................

--- End quote ---

Yes, that fixed it; I now have a WiFi icon showing in the panel.
Marvelous work, many thanks to you Sir!
I am just beginning to find that this operating system has some nice little accessible facilities like the "Lite Tweaks", and I have only just started with it.
Jim.

stevef:
Ok, let's see if we can get the Network icon back.

This should restore it back to default settings.

Menu -> Settings
scroll down the list and click on 'Lite Tweaks'
on the window that opens
scroll down and select the 'Taskbar Restore' job
click 'begin'

Jim0000:
This looks promising:


--- Code: ---sudo lshw -C network
[sudo] password for jim:
  *-network                 
       description: Ethernet interface
       product: NetLink BCM5906M Fast Ethernet PCI Express
       vendor: Broadcom Inc. and subsidiaries
       physical id: 0
       bus info: [email protected]:06:00.0
       logical name: enp6s0
       version: 02
       serial: b8:ac:6f:a1:fa:80
       size: 100Mbit/s
       capacity: 100Mbit/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=5.15.0-46-generic duplex=full firmware=sb v3.04 ip=192.168.1.101 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
       resources: irq:31 memory:febf0000-febfffff
  *-network
       description: Wireless interface
       physical id: 3
       bus info: [email protected]:4
       logical name: wlx90de8026e158
       serial: 90:de:80:26:e1:58
       capabilities: ethernet physical wireless
       configuration: broadcast=yes driver=rtl88x2bu driverversion=v5.13.1-20-gbd7c7eb9d.20210702_ firmware=30.20 link=yes multicast=yes wireless=unassociated
 jim  ~  sudo nmcli dev wifi list
IN-USE  BSSID              SSID  MODE   CHAN  RATE       SIGNAL  BARS  SECURITY
        00:1D:7E:BB:C2:5A  --    Infra  7     11 Mbit/s  100     ▂▄▆█  --       
 jim  ~ 


--- End code ---

Edit:

Hey Steve, it is working!
Many thanks for your patient assistance; I would never have got it going without it.

Jim.

stevef:
Maybe just a reboot did something.  We can sort out the network icon but first can you ensure your system is in range of some wifi networks and then run two commands and post back.


--- Code: ---sudo lshw -C network
--- End code ---
To ensure the wifi adapter is on the system


--- Code: ---sudo nmcli dev wifi list
--- End code ---
To list any networks it can see

Jim0000:

--- Quote from: stevef on August 27, 2022, 03:31:43 PM ---Jim,

In this post the USB device is now showing and has a driver when compared with your earlier post number 15 where it wasn't listed.........
Did you change anything between posts ?............
--- End quote ---

No. At least, not that I am aware of.


--- Quote ---Can you now see wireless networks detected ?
Steve.............
--- End quote ---

No. And also, I cannot see the network connections icon in the bottom panel. It was there before showing Ethernet connection.

Navigation

[0] Message Index

[#] Next page

Go to full version