Linux Lite Forums

Linux Newbie here,  I just replaced my CyberPower UPS With A Tripp Lite 750A.

Linux 'saw' the CyberPower and I had the ability to set a timeout to shut down when the power went out.

If I look under the hardware/usb I see Tripp Lite Internet750U listed among the hardware but I don't have the little utility I saw on my
task bar to configure the shut down like I did with the CyberPower

Any suggestions?

Is your hardware on this list ?

https://networkupstools.org/stable-hcl.html

If so, then might give you a lead.

I gave up, CostCo had a better UPS Unit which is a CyberPower with longer run time that was $3 more than the APC.  Amazon took the APC back, no questions asked and I got the CyberPower unit.

The moment I plugged it in I could once again configure what to do when on UPS Battery power (Critical Power)