Linux Lite Forums
Hardware - Support => Start up and Shutdown => Topic started by: C0nfused on November 12, 2016, 06:50:27 AM
-
i have a new "used" HP 6475b powerbook with a fresh win 7 home install. i put LL3 on in dual boot [120 Gb LL 200 Gb Win7]. i did see some "message" flash at top left of screen but it was gone too quickly to read. Win7 boots. after it did a CHKDSK then it boot just fine. however, linux will start at the boot menu, and when it starts to load the screen goes blank. no cursor nada, zilch
. there is "some" slight random HDD activity .
Operating System Windows 7 Home Premium (x64) Service Pack 1 (build 7601)
Install Language: English (United States)
System Locale: English (United States)
Installed: 7/21/2016 2:16:58 PM
Boot Mode: Legacy BIOS in UEFI (Secure Boot not supported)
System Model Hewlett-Packard HP ProBook 6475b A1029D110C
System Serial Number: CNU32995MQ
Chassis Serial Number: CNU32995MQ
Enclosure Type: Notebook
Processor a 2.50 gigahertz AMD A4-4300M APU with Radeon HD Graphics
96 kilobyte primary memory cache
1024 kilobyte secondary memory cache
64-bit ready
Multi-core (2 total)
Not hyper-threaded
Main Circuit Board b Board: Hewlett-Packard 180F KBC Version 47.18
Serial Number: PCWNA001X4XH0B
Bus Clock: 100 megahertz
UEFI: Hewlett-Packard 68RTU Ver. F.44 06/14/2013
hope i can get some guidance,, thanks..