[scamidge]

System Specs

Operating System – Linux Lite	Linux Lite 8.0
CPU / Processor	not sure
Memory (RAM)	16 GB
Storage	Other / not listed
Graphics (GPU)	not sure
Network device	Not sure / Unknown

Sorry, new non-technical user, first post.

Installation was fine. I have 2 SSDs and 2 internal ata drives. 1 SSD has LL and the second has Zorin. 

When using Grsynch, I noticed on LL it was slower than on Z. I asked AI. It told me to do things and I ran out of time allowed. 

Final status, when I boot, I include a startup instuction "sh -c "sleep 5 && udisksctl mount -b /dev/disk/by-uuid/b69fe174-b930-47dd-add6-5f154bb35a7e && udisksctl mount -b /dev/disk/by-uuid/8f5a9fdd-9386-4752-ad0b-3e75e50a5400" otherwise Thunar will not mount the drives until I click on them. And the AI did mention something about changing the timing.

How do I get back to mounting properly without the startup instruction? 

Thank you for any comments. Remember please I am a new non-technical user.

[stevef]

How do I get back to mounting properly without the startup instruction?

Undo/remove all the changes introduced under AI instruction.

Have you seen these two sections in the wiki ?
If not, they may be relevant.

https://wiki.linuxliteos.com/en/install....partdrives
Describes manually mounting drives.

https://wiki.linuxliteos.com/en/install....partdrives
Describes automatically mounting drives.