[SOLVED]Installing Updates

[Kalifornia]

Okay, so I ran the remove kernal thing and cutter install before doing updates. After rebooting, I had no Wi-Fi again. I tried the modprobe stuff too, but all it did was create a new line in the Terminal. Nothing happened. Here's the network output:

*-network:0 UNCLAIMED 
      description: Network controller
      product: BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller
      vendor: Broadcom Corporation
      physical id: 3
      bus info: pci@0000:02:03.0
      version: 02
      width: 32 bits
      clock: 33MHz
      configuration: latency=64
      resources: memory:dfdfe000-dfdfffff
  *-network:1
      description: Ethernet interface
      product: 82562ET/EZ/GT/GZ - PRO/100 VE (LOM) Ethernet Controller Mobile
      vendor: Intel Corporation
      physical id: 8
      bus info: pci@0000:02:08.0
      logical name: eth0
      version: 03
      serial: 00:12:3f:f7:43:ed
      size: 10Mbit/s
      capacity: 100Mbit/s
      width: 32 bits
      clock: 33MHz
      capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
      configuration: autonegotiation=on broadcast=yes driver=e100 driverversion=3.5.24-k2-NAPI duplex=half latency=64 link=no maxlatency=56 mingnt=8 multicast=yes port=MII speed=10Mbit/s
      resources: irq:20 memory:dfdfd000-dfdfdfff ioport:df40(size=64)