wireless networks "device not ready"

[BilyJimyBobb]

again, something happening to my post/replies, here's the LAST of the two (LL6) pairs of command results, that i THOUGHT were successful only a couple of hours ago:

sudo lspci -s 00:14.3 -v
00:14.3 Network controller: Intel Corporation Device 54f0
Subsystem: Intel Corporation Device 4070
Flags: bus master, fast devsel, latency 0, IRQ 16
Memory at 6001144000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [c8] Power Management version 3
Capabilities: [d0] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [40] Express Root Complex Integrated Endpoint, MSI 00
Capabilities: [80] MSI-X: Enable+ Count=16 Masked-
Capabilities: [100] Latency Tolerance Reporting
Capabilities: [164] Vendor Specific Information: ID=0010 Rev=0 Len=014 <?>
Kernel driver in use: iwlwifi
Kernel modules: iwlwifi

sudo dmesg | grep -i -E 'crf|00:14.3|iwl|wlp0s20f3'
[    0.352187] pci 0000:00:14.3: [8086:54f0] type 00 class 0x028000
[    0.352317] pci 0000:00:14.3: reg 0x10: [mem 0x6001144000-0x6001147fff 64bit]
[    0.353149] pci 0000:00:14.3: PME# supported from D0 D3hot D3cold
[  43.929286] iwlwifi 0000:00:14.3: enabling device (0000 -> 0002)
[  43.937613] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-so-a0-hr-b0-66.ucode failed with error -2
[  43.937657] iwlwifi 0000:00:14.3: Direct firmware load for iwlwifi-so-a0-hr-b0-65.ucode failed with error -2
[  48.041169] iwlwifi 0000:00:14.3: api flags index 2 larger than supported by driver
[  48.041195] iwlwifi 0000:00:14.3: TLV_FW_FSEQ_VERSION: FSEQ Version: 0.0.2.25
[  48.041577] iwlwifi 0000:00:14.3: loaded firmware version 64.97bbee0a.0 so-a0-hr-b0-64.ucode op_mode iwlmvm
[  49.701486] iwlwifi 0000:00:14.3: Detected Intel® Wi-Fi 6 AX201 160MHz, REV=0x370
[  49.813735] iwlwifi 0000:00:14.3: Detected RF HR B3, rfid=0x10a100
[  49.879886] iwlwifi 0000:00:14.3: base HW address: d4:f3:2d:a7:16:ba
[  49.898269] iwlwifi 0000:00:14.3 wlp0s20f3: renamed from wlan0
[  488.753573] wlp0s20f3: authenticate with 2c:95:69:e2:e5:49
[  488.760127] wlp0s20f3: send auth to 2c:95:69:e2:e5:49 (try 1/3)
[  488.788360] wlp0s20f3: authenticated
[  488.796547] wlp0s20f3: associate with 2c:95:69:e2:e5:49 (try 1/3)
[  488.798767] wlp0s20f3: RX AssocResp from 2c:95:69:e2:e5:49 (capab=0x411 status=0 aid=5)
[  488.805384] wlp0s20f3: associated
[  488.913285] wlp0s20f3: Limiting TX power to 27 (30 - 3) dBm as advertised by 2c:95:69:e2:e5:49
[  488.933176] IPv6: ADDRCONF(NETDEV_CHANGE): wlp0s20f3: link becomes ready