06-22-2019, 11:34 AM
You can open the editable xml page for your firewall with the following command: sudo ufw status verbose
You can change settings with the CLI. Make sure the defaults are deny (incoming) allow (outgoing) first, then you can allow or disallow ports.
See the link below for what it looks like:
https://www.dbts-analytics.com/webserv3.html
TC
You can change settings with the CLI. Make sure the defaults are deny (incoming) allow (outgoing) first, then you can allow or disallow ports.
See the link below for what it looks like:
https://www.dbts-analytics.com/webserv3.html
TC
All opinions expressed and all advice given by Trinidad Cruz on this forum are his responsibility alone and do not necessarily reflect the views or methods of the developers of Linux Lite. He is a citizen of the United States where it is acceptable to occasionally be uninformed and inept as long as you pay your taxes.