UEFI Build Test

[firenice03]

Many thanks for your reply, firenice03. Yes... I take your point, though in 'Something Else' I had already installed the LL bootloader to /dev/sda2 where the Windows EFI partition was (rather than /dev/sda as used in the Legacy install) - I think this was the correct thing to do?  Yes, GPT disk used to allow UEFI/Secure boot install.  Though I appear unable to dualboot LL3.2 UEFItestbuild with Win10, I am able to dualboot Linux Mint 18 with Win10 with UEFI/Secure boot enabled.

hhhmmm - I'll look at mine and see if I can recall anything (I forgot I was going to check).. The only thing I may have done differently is install LL3.2 to another disk (SDCard) vs. the main..

I re-read another post.. you mentioned

Code:

As I'm installing in CSM mode (Legacy)

; perhaps this?? You shouldn't need Legacy since you're using the UEFI version (although I'd assume it should work)..
You can leave UEFI enabled; Secureboot probably will need disabled to boot from USB (but could try enabled)..