[SOLVED] Transfer LL from laptop to desktop w/ win7 sp1 (side-by-side)

[tripple aught]

  You were absolutely correct.... The first time I ran just the install for fixparts without the commands. (ooops)

    Latest times to run have been with commands.

    Here are the 'prep' screens (df -h)  (sudo blkid)  (sudo parted -l) I did this just to see the different information provided.

Code:

linux@linux:~$  df -h
Filesystem      Size  Used Avail Use% Mounted on
/cow            929M   45M  884M   5% /
udev            915M  4.0K  915M   1% /dev
tmpfs           186M  1.4M  185M   1% /run
/dev/sr0        738M  738M     0 100% /cdrom
/dev/loop0      706M  706M     0 100% /rofs
none            4.0K     0  4.0K   0% /sys/fs/cgroup
tmpfs           929M   16K  929M   1% /tmp
none            5.0M     0  5.0M   0% /run/lock
none            929M   80K  929M   1% /run/shm
none            100M   24K  100M   1% /run/user
linux@linux:~$

Code:

linux@linux:~$ sudo blkid
/dev/loop0: TYPE="squashfs"
/dev/sda1: LABEL="System" UUID="08C2894BC2893E46" TYPE="ntfs"
/dev/sda2: LABEL="WIN 7 SP 1" UUID="889C8B189C8B0044" TYPE="ntfs"
/dev/sr0: LABEL="Linux Lite 2.2 64-bit" TYPE="iso9660"
/dev/sdb1: LABEL="USB20FD" UUID="2A72-97E1" TYPE="vfat"
linux@linux:~$

Code:

linux@linux:~$ sudo parted -l
Model: ATA WDC WD800JD-60LS (scsi)
Disk /dev/sda: 80.0GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos

Number  Start   End     Size    Type     File system  Flags
1      1049kB  4030MB  4029MB  primary  ntfs         boot, diag
2      4030MB  46.3GB  42.3GB  primary  ntfs


Model: PNY USB 2.0 FD (scsi)
Disk /dev/sdb: 8167MB
Sector size (logical/physical): 512B/512B
Partition Table: msdos

Number  Start   End     Size    Type     File system  Flags
1      28.7kB  8167MB  8167MB  primary  fat32        lba


Warning: Unable to open /dev/sr0 read-write (Read-only file system).  /dev/sr0
has been opened read-only.
Error: Invalid partition table - recursive partition on /dev/sr0.         
Ignore/Cancel? I                                                         
Model: TSSTcorp DVD-ROM TS-H353C (scsi)
Disk /dev/sr0: 774MB
Sector size (logical/physical): 2048B/2048B
Partition Table: msdos

Number  Start  End  Size  Type  File system  Flags


linux@linux:~$

>  I re-downloaded the Fixparts App and ran it again from Live LL disk on desktop.

>  There is a message on the 'install screen' : "same version is already installed"

> Pull up the command terminal and...

Code:

linux@linux:~$ sudo fixparts /dev/sda
sudo: fixparts: command not found
linux@linux:~$

I know it's frustrating... but keep in mind that you are being blessed for helping the poor, old, blind, cripple folks .