Hardware - Support > Printing and Scanning

Problems installing Epson XP-445 Network Scanner

<< < (2/2)

Hello Paul

Thanks for the additional informations's,
I personally didn't got a problem with the connection caused by the firewall,
but I'm shure it will help somebody else.



Albert John:
You can replace you motherboard with new one, This issues solved your problem permanently and you will fell better. But If you are not able to replace motherboard with new one then you can solve your problem with the help of another option Like you can repair your printer and solve your problem.

You can use this solution also OFF your printer suddenly remove all cables and USB drives after two minutes, plug all cables and On your printer and check that its work or not. you should clean your printer with wipe napkin and warm water but after remove all plug and you will be do this work carefully. I also read this somewhere because i also have a printer and I had solved my Epson printer error code 0x97 problem.

Hello All

now after a long time without a network scan problem, I got the problem again
there was nothing changed at the system only normal updates.

I tried following:

1. Disable Firewall >> No effect
2. Install the driver again >> No effect
3. I also added the device ID to the network IP adress >> No effect

Problem picture


it was detected as showed at picture above after click scann >> Error >> Could not connect to the scanner

After start imagescan error at access to scanner error receiving not possible

At strat error problem at open the scann ..... operation not supported

Did somebody have an idea how to solve this issue?

Thanks and greetings



I just saw your problem right now.

Could you tell us how it was solved ?


[0] Message Index

[*] Previous page

Go to full version