Hardware - Support > Network
Wireless not connecting after reboot
ooseven:
Does this help?
denny@Q:~$ ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:16:36:39:ca:e9
inet addr:192.168.0.12 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::216:36ff:fe39:cae9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:31 errors:0 dropped:0 overruns:0 frame:0
TX packets:74 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3456 (3.4 KB) TX bytes:12752 (12.7 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:66 errors:0 dropped:0 overruns:0 frame:0
TX packets:66 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4186 (4.1 KB) TX bytes:4186 (4.1 KB)
wlan0 Link encap:Ethernet HWaddr 00:16:ce:43:f8:49
inet6 addr: fe80::216:ceff:fe43:f849/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:115 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:22060 (22.0 KB)
N4RPS:
Hello!
It SHOULD be just matter of right-clicking the network icon, selecting 'Edit Connections', deleting the connection located behind the 'VPN' tab, and adding the connection back - this time, under the 'Wireless' tab.
Now if it's adding things to VPN connections automatically, or by default, I'm clueless. I've NEVER seen *THAT* before...
73 DE N4RPS
Rob
ooseven:
I installed 1.08 on a acer aspire 3000 for a friend. I have to make a network connection
and it works till I reboot. It is set to connect automatically. It does not show up in the
network icon down by volume. When open the VPN connection it is in there.
But does not start or even let me click on it to connect. Never had this problem bfore,
had install drivers before but not this.
Navigation
[0] Message Index
[*] Previous page
Go to full version