Linux Lite Forums

my samsung scanner clx6260 have run fin under previous ll ver, now i made a clean install of ll 4.2 and scanner dont work the printer goes fine as is the same maskin clx6260 i stopped the firewal did not help 

[member=80]iwar[/member] ,


Consider installing the Linux driver for your printer/scanner.  I found it here:
https://support.hp.com/us-en/drivers/sel...p-191129-2

thanks but it is the same driver I have it work fine before with Linuxlite series 3.x but now i installed 4.2 and the printer goes fine but the scanner do not. itś a multimaskin

I came across this...
https://bugs.launchpad.net/ubuntu/+sourc...ug/1741977


Has a work around by adding an environmental variable...
Might be worth a try...

firenice03 I tyed it but no success it seem very right for me but,
It seems to be for usb connection My samsung is conectet via tcp/ip direct to the router and hav been so before workt very fine.from all ouers computers windows and linux

check the linux driver available here https://www.printerdriverforwindows.com/...g-clx-6260

hridayar
I lookt in to it its the very same files that i have but the scripts are older but i will try them. Thanks hridayar

still no scanner maybe i have to go back to a older Linuxlite!

I also have a Samsung printer/scanner/copier that is connected via ethernet cable to my home network.
I could not get the scanner to work no matter what I tried.
After much researching, I finally found a solution.

On the printer menu, I gave the printer a static address,
in my case it is 192.168.2.111.

Then I added the line,    tcp 192.168.2.111
to /etc/sane.d/xerox_mfp.conf

Like magic, the scanner then worked.

Thanks arky217 i try that, there are som win10 on this network to is that a problem? / Ivar