12-07-2016, 05:24 PM
Epson Perfection V500 flatbed scanner worked fine in LL2 series but not with LL3 series.
Output from terminal is as follows:
From the above, the scanner seems to be detected but subsequently running the 'scan' command results in the following iscan notification: 'Could not send command to scanner. Check the scanner's status.'
I'm clueless as to what to do next... extremely frustrating
Mike
I suspect with the following installed before running with 'iscan':
Output from terminal is as follows:
Code:
mike@mike-G750JS:~$ sudo sane-find-scanner
[sudo] password for mike:
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x04b8 [EPSON], product=0x0130 [EPSON Scanner]) at libusb:003:002
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
mike@mike-G750JS:~$ sudo scanimage -L
device `epkowa:interpreter:003:002' is a Epson Perfection V500 flatbed scanner
mike@mike-G750JS:~$ iscanFrom the above, the scanner seems to be detected but subsequently running the 'scan' command results in the following iscan notification: 'Could not send command to scanner. Check the scanner's status.'
I'm clueless as to what to do next... extremely frustrating
Mike
I suspect with the following installed before running with 'iscan':
